Axis Wakeboard Boat Forum http://axiswakeboardboats.com/ |
|
Indmar Pro Sea Strainer http://axiswakeboardboats.com/viewtopic.php?f=16&t=4311 |
Page 1 of 1 |
Author: | Rmilbour [ Sat Jul 15, 2017 11:39 am ] |
Post subject: | Indmar Pro Sea Strainer |
My 2015 A20 sucks up too much debri and constantly overheats. Bought an Indmar Pro Strainer and installed it. Here are some pics if anyone is thinking of installing it. Tools- Hacksaw, flat head screwdriver. When you cut out a portion of the intake hose the hacksaw works great, be careful of the wire- its sharp when you cut it and got me a couple times. Error on the side of cutting too little of the hose. Review- Works great, easy to install, can clean out debris in 30 seconds and be boating again. Hose attachment is great for dry starts. Only con I can see so far is the plastic it's made out of. Not sure how long it will last before cracking. Cost was about $90ish for the entire project. Sent from my iPhone using Tapatalk |
Author: | buffaxis [ Sat Jul 22, 2017 6:58 pm ] |
Post subject: | Re: Indmar Pro Sea Strainer |
i have had mine for a two summers and it works great. easy cleanup and great for winterizing.. where do you surf? the water is so brown? |
Author: | Rmilbour [ Tue Aug 08, 2017 9:47 pm ] |
Post subject: | Re: Indmar Pro Sea Strainer |
buffaxis wrote: i have had mine for a two summers and it works great. easy cleanup and great for winterizing.. where do you surf? the water is so brown? We surf / boat at Lake Nacimiento. It's near Paso Robles in Cali. The Strainer has been a welcome addition! Saving me a ton of busted knuckles trying to get to the oem debri screen. Sent from my iPhone using Tapatalk |
Author: | Fordyce [ Thu Nov 30, 2017 11:06 am ] |
Post subject: | Re: Indmar Pro Sea Strainer |
Good to know. Thanks for sharing your experiences Rmil. I might get it myself. |
Author: | Raimie [ Thu Oct 11, 2018 9:04 pm ] |
Post subject: | Re: Indmar Pro Sea Strainer |
Can you please explain the routing for me? Isn't the intake supposed to route to the water pump? I would like to tackle this project before next winter... |
Author: | Bryan1 [ Mon Oct 15, 2018 1:30 pm ] |
Post subject: | Re: Indmar Pro Sea Strainer |
Raimie wrote: Can you please explain the routing for me? Isn't the intake supposed to route to the water pump? I would like to tackle this project before next winter... The water comes in and goes thru the v-drive, then the transmission cooler then back to the water pump. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |