| Axis Wakeboard Boat Forum http://axiswakeboardboats.com/ |
|
| How do I use the ACC switches? http://axiswakeboardboats.com/viewtopic.php?f=16&t=3531 |
Page 1 of 1 |
| Author: | pilotflying [ Fri Apr 01, 2016 10:10 am ] |
| Post subject: | How do I use the ACC switches? |
I would like to control my DIY-LED-install with one of the ACC switches. I have looked behind the dash and was surprised to see three cables going to each of the ACC Switches. I wouldn't have expected them to have cables at all. These cables lead to a connector which goes into what looks like the main cable bus of the boat. On the circuit breaker Panel I have found CBs for both ACC Switches. My question is where is the correct point to tap into the ACC Switches so I can also make use of the factory CBs? |
|
| Author: | alexandera [ Sun Apr 03, 2016 8:30 am ] |
| Post subject: | Re: How do I use the ACC switches? |
The single throw acc switch should already have a ground and a hot connected to it. The ground may even be piggybacked to another adjacent switch. You should have one blank blade ready to receive a female connector. Pull your new wire for your accessory and attach the hot to the blank blade and splice into the ground with a t-tap connector. Use a minimum of 16AWG wire to minimize resistance. Double-throw is a little more complicated, but same concept, depending on how the double-throw operates. (on1-off-on2 vs. on1-off-on1+2). |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|