Axis Wakeboard Boat Forum http://axiswakeboardboats.com/ |
|
Where to flush engine?? http://axiswakeboardboats.com/viewtopic.php?f=14&t=742 |
Page 1 of 1 |
Author: | 757/a22 [ Sun Jun 17, 2012 9:18 am ] |
Post subject: | Where to flush engine?? |
if not equipped with the salt water series engine flush connection, where can you flush the engine? I see there is a hose you can disconnect on the engine that is for raw water, can you just hook a garden hose up and flush that way? I used in brackish water this weekend. |
Author: | nastya20 [ Sun Jun 17, 2012 9:38 am ] |
Post subject: | Re: Where to flush engine?? |
Make your own flush kit, or you can buy a fake a lake- or install an inline perko flush kit. here's a cheap diy solution I'm using. Beats paying 40 bucks for the flush kits. Go by a hardware store and buy plunger and a male hose end. Make small hole (smaller than hose tube diameter) and then shove the hose male end in. I use the wood blocks to bridge the gap between plunger and concrete. |
Author: | Gibster786 [ Sun Jun 17, 2012 2:32 pm ] |
Post subject: | Re: Where to flush engine?? |
That is not a bad way to winterize your ballast tanks. I am going to make one. As for flushing I have the flush rig from the factory since I bought a Vandall. NO WAY YOUR IN THE 757. Hit me up and lets go out! Did you get your boat from centerville? |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |